2nd Generation Uprights

[Blueovalz]

Needed to change the geometry just a bit, and lose some unsprung weight, so I'm working on a second set of uprights. These will again be steel fabrication, but using sheet steel instead of the square tubing I used in the first ones I built. After finishing up the first one, I've come to realize I could probably make the second set out of 12 and 14 gauge, rather than 11 and 12, thus saving a little more weight. As these sit, they are still 4 lbs lighter than the first set I built.

http://www.fototime.com/F583407FBEE6848/standard.jpg

http://www.fototime.com/B89D88E061514D5/standard.jpg

http://www.fototime.com/3041C3A90370392/standard.jpg

http://www.fototime.com/1753A52A5289A75/standard.jpg

http://www.fototime.com/F3DB7AD412722D0/standard.jpg

http://www.fototime.com/D869E2CAB387F9C/standard.jpg

[Nidrahynnad]

Very nice!
From the time of your post, it looks like Santa was up late/early to finish this for you!

Dan

[Blueovalz]

Test fitting them to the car. 12 lbs in weight (4 lbs lighter than the old test-fit prototypes) that I built in order to get the car on the road. Eventually I will go with an aluminum billet upright, but I found through testing that I needed more camber gain during suspension travel, so before I spend a lot of money on the aluminum ones, I would instead try my hand with a sheet metal upright that was lengthened about 1" (upper arm moved up from axle centerline by about 1"). Going to the powder coater tomorrow to beautify these up a bit so they don't look so rough.

http://www.fototime.com/C4A2EF7514D1186/standard.jpg

http://www.fototime.com/1F3F459E6B4DA31/standard.jpg

http://www.fototime.com/19988558C02A6E9/standard.jpg

http://www.fototime.com/81C1A0B550E35B7/standard.jpg

http://www.fototime.com/330A97BFA6ED163/standard.jpg

[Blueovalz]

Powdercoated.

http://www.fototime.com/DC5B96F32476E57/standard.jpg

http://www.fototime.com/B7EE9CFCCA625D6/standard.jpg

http://www.fototime.com/C71A531A2A401E6/standard.jpg

[Sulley]

You are definitely an 'artist'!