Ken where did you have your axles fabricated?
Ken where did you have your axles fabricated?
As for the axles (half axles, actually), I had a driveshaft shop in Colorado Springs make them. Any good driveshaft shop should be able to fab them and BALANCE them (after all, the half axles are pretty much just "short driveshafts").Originally Posted by Sulley
The trick on going from a Porsche transaxle to the half axles, however, are the adapters I machined from steel. They are the chromed pieces that mount to the Porsche stub diff stub shafts to the fabricated half axles. I took "one route" to do this; there are others as well.
As for the "radius rods" chromed rods with heim joint rod ends, I cut those from DOM steel tubing and threaded ends/bungs.
Ken
Posting Permissions
Reply With Quote