Results 1 to 5 of 5

Thread: 2nd Generation Uprights

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Champion Member Blueovalz's Avatar
    Join Date
    Jul 2014
    Location
    Little Rock, AR
    Posts
    279

    2nd Generation Rear Uprights

    Needed to change the geometry just a bit, and lose some unsprung weight, so I'm working on a second set of uprights. These will again be steel fabrication, but using sheet steel instead of the square tubing I used in the first ones I built. After finishing up the first one, I've come to realize I could probably make the second set out of 12 and 14 gauge, rather than 11 and 12, thus saving a little more weight. As these sit, they are still 4 lbs lighter than the first set I built.











    Last edited by Blueovalz; 01-06-2016 at 09:04 AM.

  2. #2
    Pole Position Member
    Join Date
    Aug 2014
    Location
    Cape Coral, Florida
    Posts
    68
    Very nice!
    From the time of your post, it looks like Santa was up late/early to finish this for you!

    Dan

  3. #3
    Champion Member Blueovalz's Avatar
    Join Date
    Jul 2014
    Location
    Little Rock, AR
    Posts
    279
    Test fitting them to the car. 12 lbs in weight (4 lbs lighter than the old test-fit prototypes) that I built in order to get the car on the road. Eventually I will go with an aluminum billet upright, but I found through testing that I needed more camber gain during suspension travel, so before I spend a lot of money on the aluminum ones, I would instead try my hand with a sheet metal upright that was lengthened about 1" (upper arm moved up from axle centerline by about 1"). Going to the powder coater tomorrow to beautify these up a bit so they don't look so rough.









    Last edited by Blueovalz; 12-30-2015 at 05:32 PM.

  4. #4
    Champion Member Blueovalz's Avatar
    Join Date
    Jul 2014
    Location
    Little Rock, AR
    Posts
    279

    2nd Generation Rear Uprights

    Powdercoated.





    Last edited by Blueovalz; 02-10-2016 at 09:36 PM.

  5. #5
    Administrator Sulley's Avatar
    Join Date
    Sep 2012
    Location
    Atlanta
    Posts
    294
    You are definitely an 'artist'!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •